Conversion Calculator Module

This module is used to convert gage readings into offset corrections. Offsets are made at the machine HMI. Offset amounts are displayed in both inches and millimeters because offsets must be entered in inches on Allen Bradley controllers and in millimeters on Siemens controllers.

To use this module:

1.	Look up the feature specification on the DCP sheet and enter the value into the first data box.
2.	Enter the gage reading into the second data box
3.	Click on the Convert button. The offset amounts will be displayed in inches and millimeters.

Enter the feature specification from DCP sheet (in inches):
Enter the Gage reading (in inches):


Amount necessary to bring the feature into spec (in inches):
Amount necessary to bring the feature into spec (in mm):